Water Sanitizer Installation and Service

Sanitizer ASC-1®

The ASC-1 Sanitizer Series is the only multi-purpose water treatment system that effectively removes hardness, iron and manganese; raises pH; and disinfects itself automatically during regeneration.

Media: Crystal-Right CR-100

Capacity Specifications for the ASC-1 Sanitizer Series

MODEL		ASC1-1044	ASC1-1054	ASC1-1354
⁽¹⁾Capacity: Grains/Lbs. NaCl	Maximum	11,800 @ 12.4	22,600 @ 15.9	36,900 @ 21.2
	Medium	11,400 @ 9.3	20,700 @ 12.4	33,600 @ 15.9
	Minimum	7,300 @ 3.2	16,400 @ 6.1	28,300 @ 9.5
Amount of Media (Cu. Ft.)		1.0	1.5	2.5
Maximum Water Hardness (GPG)		20	30	40
⁽²⁾Maximum Iron (PPM)		8	10	15
⁽³⁾Minimum pH Required		6.5	6	6
⁽⁴⁾Total pH Adjusted Water at Continuous Flows		630	252	432
⁽⁵⁾Peak Flow Rate (GPM @ P-PSI)		19 @ 15	17@15	19 @ 15
Continuous Flow Rate (GPM @ P-PSI)		9 @ 5psi	8 @ 5	9 @ 5
Water Pressure Range (PSI)		25 – 100	25 – 100	25 – 100
Water Temperature (^oF)		33 – 100	33 – 100	33 – 100
Electrical Requirements (volts-hertz)		110 – 50/60	110 – 50/60	110 – 50/60
Pipe Size		1″	1″	1″
Tank Size	Media Tank	10″(w) x 52 “(h)	10″(w) x 62 “(h)	13″(w) x 62 “(h)
Tank Size	Brine Tank	18″(w) x 33″(h)	18″(w) x 33″(h)	18″(w) x 40″(h)

¹ All Water-Right Water Conditioners are pre-factory set at medium salting. Note: influent waters must be at least 3 GPG. A calcite or corsex unit may be needed for correct operation.
² Iron removal may vary depending on form of iron, pH and other local conditions. On waters that are pre-chlorinated or where other pre-oxidation occurs, an iron precipitate can form that is too small to be filtered.
³ The pH listed is the minimum for the influent water.
⁴ This is the minimum number of gallons at the continuous flow rate corrected to a 7 pH. The actual amount of pH adjusted water may be greater.
⁵ Unit not tested for capacity at these flow rates. Water quality may vary.